![]() ![]() Hardware: Chinese breakout board with USB connection, PriceCNC AVHC10 torch height controll, Z axis with floating head G31 probingĬtrl:AppendText("plasma AVHC10 post processor\n")Ĭtrl:AppendText("Modal G-codes and coordinates\n")Ĭtrl:AppendText("Comments enclosed with ( and )\n")Ĭtrl:AppendText("M03/M05 turn the torch on/off\n")Ĭtrl:AppendText("The torch is referenced at cut start and every 50mm of movement thereafter\n")Ĭtrl:AppendText("Designed for use with Mach3 and PriceCNC AVHC10\n")Ĭtrl:AppendText("refdistance - set the distance between each reference\n") I don't know if it has something to do with mach3, sheetcam/post processor or my breakout board!? here are some of my specs and i hope someone can help me but when i turn off THC mode on mach3 it executes the line just fine and after each cut it goes 30 mm up and than moves to the next cut but i cant just cut without THC because the material is very warped. on the G code is a G00 Z30 line after each cut but it gets always ignored and the torch just goes to the next cut with that same height it was cutting and catches on the very warped material i use. I have set the rapid clearance 30 mm on sheetcam and in the post processor i use says that the torch will be referenced out at start of cut and every 50mm of movement thereafter but that never happens. ![]() I use Mach3 and Sheetcam, both have their licenses installed. I'm having trouble with my CNC plasma tabel. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |